Connecting SPS985 to Trimble Yuma 2 for FW Mobile

I got an SPS985 to connect to FW Mobile and it was giving me corrections but I wasn't using my RTK base station. How do I need to go about getting the corrections from the base station? Also when I configured the port I set the GLL, GGA, RMC, and VTG to 2 sec, there were also options for 20Hz all the way down to 2Hz and the same with the seconds. What should I set this on to get the best position?

Thank you,

William



Edited 1 time(s). Last edit at 11/20/2017 07:05PM by henry.cardwell.